company's product

Contact: Cheng Manager Mobile Number: 15358420032
Enterprise fixed line: 0512-58554322
Customer Service QQ: 2282113449, 1514436998
Company E-mail:
Company Address: Sanxing Development Zone, Jinfeng Town, Zhangjiagang City, Suzhou City, Jiangsu Province, Zhangjiagang City, Jiangsu Province

Home > news > What are the effective measures to make the hot and cold cylinders durable?
What are the effective measures to make the hot and cold cylinders durable?
Edit:Zhangjiagang Tianbao Machinery Manufacturing Co., Ltd.   PublicDate:2018-08-06

1. Description: Before using the hot and cold tank , the liquid reservoir must be cleaned with fresh hot water and then steamed. The material slurry enters the cylinder from the material pipe fixed on the cylinder head, or is poured into the open cylinder head. The material should not be packed too full to prevent the material from being splashed when it is mixed by the mixer, resulting in unsanitary or loss of environment.

2. Heating method: It is necessary to close the refrigerant inlet pipe when heating, put out the remaining refrigerant in the jacket, input the material, start the mixer, and then open the steam valve. After reaching the required temperature, the steam valve should be closed first. After 2~3 minutes, turn off the mixer.

3. Cooling method: Close the steam valve, release the steam condensate from the jacket, and then open the refrigerant valve at the bottom of the hot and cold cylinder to make the refrigerant pass through the jacket and lower the temperature of the material in the cylinder.

4, insulation: according to the required temperature, start the mixer, high-speed valve, and maintain the temperature (note the temperature gauge) in order to reach the purpose of insulation.

5. Cleaning: After processing, after leaving the condensed water in the cylinder jacket of the hot and cold cylinder, it should be washed quickly with warm water, brush off the sticky material, and then thoroughly clean the inner wall of the container with 40C~50C alkaline water. Wash with water, use hot water or steam (90C) or more for the next 2 to 3 minutes of disinfection.

6. Maintenance: Always pay attention to the working condition of the whole set of equipment and reducer. When the reducer oil is lacking, it should be made up immediately. Change the oil once every half year (40# engine oil). When the equipment is not in use, it must be washed with warm water to avoid the jacket. Corrosion of salt water, often wipe the cylinder, keep the surface clean, the inner liner bright, and reach the endurance intention.